NEVER CHASE A
DROPPED SCREW
AGAIN.
MagGrip™ snaps onto any 1/4in hex drill and locks every screw dead-center with a magnetic core strong enough to lift a fistful at once. One hand. Every angle. Zero fumbling.
SCREWS DON'T
HOLD THEMSELVES.
You know the drill — pun intended. Screw in your teeth, driver in one hand, balancing on the third rung, and the second you tip the bit off-axis, it's gone. Rolling under the cabinet. Lost in the grass. Down the gap in the deck boards.
A drill only does half the job. Somebody's still holding the screw — usually with their lips, a shirt pocket, or a prayer.
- Holding it by hand at full arm extension, overhead, for the twentieth screw of the day.
- Screws in your mouth because your hands are already full of the thing you're mounting.
- Dollar-bin magnetic bits that lose their pull after a month of garage humidity.
- Plastic screw-guide clips that crack the first time you drop the driver.
THREE SECONDS.
ZERO TOOLS.
No batteries, no charging, no setup screen. MagGrip is a fully mechanical upgrade — it works the second it's on.
FOUR REASONS THIS
ISN'T A GIMMICK.
Universal Fit
Fits every standard 1/4in (6.35mm) hex-shank drill or impact driver on the market. No adapters, no guessing, no "will this even work with mine."
Machined, Not Molded
CNC-cut from solid aluminum, then anodized — not injection-molded plastic. This is a permanent upgrade to your driver, not a clip-on accessory.
Rare-Earth Magnetic Core
A concentrated internal magnet holds screws dead-center through the swing, the tilt, and the overhead reach — not just balanced, locked.
Anti-Slip Hex Grip
Hexagonal socket geometry locks against your bit shank under torque — no spin-out, no wobble, no slow leak of driving power.
WATCH THE CORE
DO THE WORK.
This isn't a single-screw parlor trick. The magnetic core is sized to hold a real fistful of drywall or wood screws mid-drive — the same force that keeps one screw dead-center at full arm's length, overhead, at an angle.
BUILT LIKE
IT MATTERS.
Every dimension on MagGrip is chosen for one job: staying locked to your driver and your screw, under real jobsite torque, indefinitely.
FOUR FINISHES.
ONE MECHANISM.
Every colorway is the exact same internal geometry and magnetic core — the anodizing is cosmetic, the performance isn't. Pick the one that matches your kit.
ANODIZED.
NOT PAINTED.
There's no paint layer to chip, scratch, or peel. The color is electrochemically sealed into the aluminum surface itself — the same process used on aerospace hardware. It fades with the drill, not with a fingernail.
STRAIGHT ANSWERS.
NO FINE PRINT.
2,847 DRIVERS.
ONE VERDICT.
"Sent me the video before I even asked for one — that's how sure they are it holds up in a real garage, not a studio."